Each of the sample layouts listed are fully described and
priced for your convenience... We
have put
together a couple of them, where each
unit is fully described, priced and drawn out for your
inspection. These can also help you assess your own situation and
even give you an idea of the cost for a similar size. Remember these
are sample layouts! Be sure to investigate the product thoroughly
before going to 'Step 1' on our estimate page and as always
you will get all
the help you need from Home Porch & Patio Kits Inc.
Links
& Complete Information
on our Modular SUNROOM Systems
"WeatherGuard" Structural Insulated Roof: 16' x 20'
(White)
Using 6" thick insulated panels - (1.5
lb. Density foam with a .024" laminated aluminum skin)includes
all the panels (White), rear hanger channel (Almond),
extruded aluminum drip edge fascia (Almond), screws &
sealant. Roof installation pitches at 1/2" per foot of
projection. Panels will
span 16'3" under 30 psf / 90 mph loading.
**Load requirement verification is customer's
responsibility
Insulated Modular Sunroom Walls - 16' (single wall)
| 19'6" (single wall) | 16' (single wall) - wall heights
from 8'5" to 7'9" as indicated in drawing
(https://www.homeporchandpatiokits.com/alpha_plus_modular_sunrooms.htm).
3.5" thick TuffCore clad EPS core walls (Almond) |
Almond extruded aluminum structural framing with
TuffCore vinyl coated polystyrene core insulated filler
sections. The insulated core sections are in place so as
to be trimmed on site, by the customer, to accommodate
exact sizes for each section, slopes and non-square
corners. Installation includes 6 electrical utility
mullions.
(2)
72" wide x 80" high sliding patio doors |
1” Sealed Double
Pane Low E Glass
All window frames:
White | All door frames: Almond
| Roof Extrusions: Almond |
All TuffCore panels: Pebble finish (exterior) panels:
Almond
All TuffCore panels:
Pebble finish (interior) panels: Almond |
All Aluminum extrusions: Almond
Estimated Delivery time is
in the 8-10 week range.
*As a DIY
application the customer should expect to be making
final cuts for roof panel sizes, module heights, channel
lengths, EPS Core fill sections, side fascia, backwall C
channel and front gutter lengths on site. Connection
hardware to existing surfaces (house wall, fascia board,
deck, patio) supplied by customer.
Alpha Plus Modular Sunroom
$35,103.46 USD
(delivered to Boulder, CO)
Pay by Visa, Master Card
Save 4% by Cashier's Check or Wire Transfer
If you want
a quick
estimate for
your size of
DIY modular
sunroom,
delivered to
your
location,
familiarize
yourself
with our
product, and
then go to
the link
below.
"WeatherGuard"
Structural Insulated Roof: 14'6" x 16' (White)
Using 4" thick insulated panels - (1.5
lb. Density foam with a .024" laminated aluminum skin)
includes all the panels (White), rear hanger channel
(Almond), extruded aluminum side fascia and front gutter
(Almond), screws & sealant. (4) x 4' wide panels will be
supplied. (1) fan beam will be installed in the center
length of (1) 4' wide panel. Customer will rip a non-fan
beam panel in half for placement on each end of the
installation, centering the fan beam panel. Customer
will determine the finished width of the roof by
trimming back the 2' wide sections. Roof installation
pitches at 1/2" per foot of projection. Quote includes 1
downspout assembly. Panels will span 15'6" under
15 psf / 100 mph loading.
**Load requirement verification is customer's
responsibility
Insulated Modular
Sunroom Walls - 14' (single wall) | 13'4" (single
wall) | 14' (single wall) - wall heights from 8'8" to
8'1" front wall height as indicated in drawing (https://www.homeporchandpatiokits.com/omega_modular_sunrooms.htm).
4" thick vinyl clad aluminum walls (Almond) | Almond
extruded aluminum structural framing with TuffCore vinyl
coated polystyrene core insulated filler sections. The
insulated core sections are in place so as to be trimmed
on site, by the customer, to accommodate exact sizes for
each section, slopes and non-square corners.
Installation includes 8 electrical utility mullions.
(1)
60" wide x 80" high sliding patio doors |
1” Sealed Double
Pane Low E Glass (Smart 60)
All window & door frames:
Almond | All TuffCore panels: Pebble
finish (exterior) panels: Almond
All TuffCore panels:
Pebble finish (interior) panels: Almond |
All Aluminum extrusions: Almond
Estimated Delivery time is
in the 6-8 week range.
*As a DIY
application the customer should expect to be making
final cuts for roof panel sizes, module heights, channel
lengths, EPS Core fill sections, side fascia, backwall C
channel and front gutter lengths on site. Connection
hardware to existing surfaces (house wall, fascia board,
deck, patio) supplied by customer.
OMEGA Modular Sunroom
$29,169.63 USD
(delivered to Salt Lake City, UT)
Pay by Visa, Master Card
Save 4% by Cashier's Check or Wire Transfer
If you want
a quick
estimate for
your size of
DIY modular
sunroom,
delivered to
your
location,
familiarize
yourself
with our
product, and
then go to
the link
below.
"WeatherGuard" Structural Insulated Roof: 14' x 20'
(White)
Using 3" thick insulated panels - (1.5
lb. Density foam with a .024" laminated aluminum skin)
includes all the panels (White), rear hanger channel
(White), extruded aluminum side fascia and front gutter
(White), screws & sealant. Roof installation pitches at
1/2" per foot of projection. Panels will span 14'7” under
10 psf / 90 mph loading. Quote includes 2 downspout
assemblies. Quote includes 1 fan beam installation.
Customer to trim 1’ off each end roof panel to get the
18’ finished width.
**Load
requirement verification is customer's responsibility
Insulated Modular Sunroom Walls – 15’11” (single
wall) | 11’8” (single wall) - wall heights from 8'2” to
7'8” front wall height as indicated in drawing (https://www.homeporchandpatiokits.com/omega_modular_sunrooms.htm).
4" thick vinyl clad aluminum walls (White) | White
extruded aluminum structural framing with TuffCore vinyl
coated polystyrene core insulated filler sections. The
insulated core sections are in place and are trimmed on
site, by the customer, to accommodate exact sizes for
each section, slopes, and non-square corners.
Installation includes 4 electrical utility mullions.
Vinyl windows constructed
with 3 ” thick framing, dual cam locks & our EZ Glide
Quad Roller system.
(2) 48" wide x 54" high
sliding windows | 1” Sealed Double Pane
Low E Glass (Smart 60)
(4) 42" wide x 54" high
sliding windows | 1” Sealed Double Pane
Low E Glass (Smart 60)
All sliding windows come with fixed exterior screens
Front Wall (OLI)
Transoms & Kickplates
Solid transoms
above all windows
Solid
kick-plates below all windows
Right Hand (OLI) Side Wall
Transoms & Kickplates
Solid transoms above
all windows & doors
Solid kick-plates below
all windows
Doors
Swing doors are 1-3/4”
thick, standard with nickel plated hardware.
Continuous Q-lon weather stripping around door
jamb and threshold – with state of the art, warm
edge elastomeric separator.
Utility Mullions
(Raceways) on both sides | Continuous Hinges |
Existing Hinge Adjuster provided | Bottom
Adjuster provided | Q-Lon Kit (3 Piece) |
Threshold
(1) 36" wide x 80" high
[in-swing] pedestrian door
| 1” Sealed Double Pane
Low E Glass (Smart 60)
All window & door frames:
White | Roof Extrusions: White
| All TuffCore panels: Stucco finish
(exterior) panels: White
All TuffCore panels:
Pebble finish (interior) panels: White |
All Aluminum extrusions: White
Estimated Delivery time is
in the 6-8 week range.
*As a DIY
application the customer should expect to be making
final cuts for roof panel sizes, module heights, channel
lengths, EPS Core fill sections, side fascia, backwall C
channel and front gutter lengths on site. Connection
hardware to existing surfaces (house wall, fascia board,
deck, patio) supplied by customer.
OMEGA Modular Sunroom
$17,238.80 USD
(delivered to Pismo Beach, CA)
Pay by Visa, Master Card
Save 4% by Cashier's Check or Wire Transfer
If you want
a quick
estimate for
your size of
DIY modular
sunroom,
delivered to
your
location,
familiarize
yourself
with our
product, and
then go to
the link
below.
I.C.C. Approval
(International Conf. of Building Officials)
IRC (International
Residential Codes)
IBC (International
Building Codes)
CBC (California
Building Code)
Meets or Exceeds
National Glass Code
Factory Built
Housing Approval
C.M.B.S.O.A.
Approval (Security Windows)
A-Rated Dual Glass
(ALI Laboratories)
U.L. Classified
Patented Electrical Raceways
AAMA Approved
Windows and Doors
Modular
Construction for Easy Installation
• Standard dual sliding window
widths of 36”, 42”, 48” and 54”
• Modules are cut and assembled in a quality controlled
environment
• Unit only requires final placement cuts at the jobsite
• Less cuts in the field requires less fillers
• Every piece is quality checked before leaving the
factory
• Less exposed fasteners and caulking
• Assembled in a fraction of the time of a KD assembly
• Installation guidelines and support available
•
Modular construction make installation a snap.
• Most
room sizes can be installed in just a couple days.
Pay by Visa, Master Card OR Save 4% by Cashier's Check
*In any case of price or information discrepancy, this web site shall be taken as correct. All prices are subject to change without notice.
Web site pricing - - In USA: is for delivery within the contiguous US and does not include freight rate up-charges to AK, HI, PR or US Virgin Islands
Toll Free: 1.844.404.0484 Fax: 1.705.259.2264 Email: web@homeporchandpatiokits.com
D&B D-U-N-S. Number: 203463054 | NATO Commercial and Government Entity (NCAGE) #L0EL4 | Registered U.S. federal government’s System for Award Management (SAM)
